Continuous Flotation Churns

Continuous butter churn diagram

The cream is first fed into a churning cylinder fitted with beaters that are driven by a variable speed motor.

Rapid conversion takes place in the cylinder and, when finished, the butter grains and buttermilk pass on to a draining section. The first washing of the butter grains sometimes takes place en route - either with water or recirculated chilled buttermilk. The working of the butter commences in the draining section by means of a screw, which also conveys it to the next stage.

On leaving the working section the butter passes through a conical channel to remove any remaining buttermilk. Immediately afterwards, the butter may be given its second washing, this time by two rows of adjustable high-pressure nozzles. The water pressure is so high that the ribbon of butter is broken down into grains and consequently any residual milk solids are effectively removed. Following this stage, salt may be added through a high-pressure injector.

The third section in the working cylinder is connected to a vacuum pump. Here it is possible to reduce the air content of the butter to the same level as conventionally churned butter.

In the final or mixing section the butter passes a series of perforated disks and star wheels. There is also an injector for final adjustment of the water content. Once regulated, the water content of the butter deviates less than +/- 0.1%, provided the characteristics of the cream remain the same.

The finished butter is discharged in a continuous ribbon from the end nozzle of the machine and then into the packaging unit.