The serum solids or milk solids-not-fat (MSNF) contain the lactose, caseins, whey proteins, and minerals (ash content) of the product from which they were derived. They are an important ingredient for the following beneficial reasons:
- improve the texture of ice cream, due to the protein functionality
- help to give body and chew resistance to the finished product
- are capable of allowing a higher overrun without the characteristic snowy or flaky textures associated with high overrun, due also to the protein functionality
- may be a cheap source of total solids, especially whey powder
The limitations on their use include off flavours which may arise from some of the products, and an excess of lactose which can lead to the defect of sandiness prevelant when the lactose crystallizes out of solution. Excessive concentrations of lactose in the serum phase may also lower the freezing point of the finished product to an unacceptable level.
The best sources of serum solids for high quality products are:
- concentrated skimmed milk
- spray process low heat skimmilk powder
Other sources of serum solids include: sweetened condensed whole or skimmed milk, frozen condensed skimmed milk, buttermilk powder or condensed buttermilk, condensed whole milk, or dried or condensed whey. Superheated condensed skimmed milk, in which high viscosity is promoted, is sometimes used as a stabilizing agent but does, then, also contribute to serum solids.
It has recently become common practice to replace the use of skim milk powder or condensed skim with a variety of milk powder replacers, which are blends of whey protein concentrates, caseinates, and whey powders. These are formulated with less protein than skim powder, usually 20-25% protein, and thus less cost, but are blended with an appropriate balance of whey proteins and caseins to do an adequate job. Caution must be exercised in excessive use of these powders, experimentation with your own mix is the best answer.
See the section on Concentrated and Dried Dairy Products for a description of the manufacture of all of the above ingredients.
The proteins, which make up approximately 4% of the mix, contribute much to the development of structure in ice cream including:
- emulsification properties in the mix
- whipping properties in the ice cream
- water holding capacity leading to enhanced viscosity and reduced iciness
- A decrease in temperature favours rapid crystallization insofar as it increases the supersaturation.
- A decrease in temperature favours slow crystallization insofar as it increases the viscosity, reduces the kinetic energy of the particles, and decreases the rate of transformation from beta to alpha lactose.
Supersaturated state can exist, however, due to extreme viscosity, and it is likely that much of the lactose in ice cream is non-crystalline. Stabilizers help to hold lactose in supersaturated state due to viscosity enhancement. Fruits, nuts, candy - add crystal centers and may enhance lactose crystallization. Nuts pull out moisture from ice cream immediately surrounding the nut thus concentrating the mix.
Citrate and phosphate ions decrease tendency for fat coalescence (Sodium citrate, Disodium Phosphate). They prevent churning in soft ice cream for example, producing a wetter product. These salts decrease the degree of protein aggregation. Calcium and magnesium ions have the opposite effect, promote partial coalescence. Calcium sulfate, for example, results in a drier ice cream. Calcium and Magnesium increase the degree of protein aggregation.
Salts may also influence electrostatic interactions. Fat globules carry a small net negative charge, these ions could increase or decrease that charge as they were attracted to or repelled from surface.